Default is three seconds, although valid range is from 1 to 120.
Tftp server port free#
port-range, port range on which TFTP server would respond from (default is any free port).section through which you can further configure the TFTP server behavior:.
Through IP ranges you can control allowed clients, this range effectively disallows 10.44.1.12: ALLOWED-CLIENTS section specifies permitted clients for TFTP Access.
Tftp server port windows#
Logging only runs when TFTP server is run as a Windows Service. TFTPServer.log is created in the same directory as the TFTP executable. All is resource intensive and not recommended.
Second: I'd change your first setting to -A INPUT -i eth0 -s 192.168.1.0/24 -p udp -dport 69 -m state -state NEW,ESTABLISHED -j ACCEPT In this case you probably have a router as firewall to the internet, so you do not need any iptables configuration. Just to be sure: This is a LAN ip, so this will only work, if your server and client are part of the same LAN. First of all: You only allow connections to your server with a source ip matching "192.168.1.0/24".